Used Motor Oil On Wood Deck

Used Motor Oil On Wood Deck. Used motor oil can perfectly preserve the wood. Make sure this fits by entering your model number.

Hot Rods Finishing a wood truck bed The H.A.M.B. from www.jalopyjournal.com

Scrub surface with dawn dish soap, rinse well. Make sure you put it on when the sun is beaming down and the poors are open in the wood. It gives v good protection but ends must be soaked in oil for a long time to be effective.

Source: www.greentractortalk.com

Used motor oil can perfectly preserve the wood. Motor oil will go on soaking into the wood as long as you feed it, because it never dries.

Source: www.lawnsite.com

Never use any gun oil on wood. Try buying a deck stain that.

Source: www.lawnsite.com

Soaks in good that way. It keeps sipping deeper into the wood.

Source: forum.ih8mud.com

Splashed on and spread it out with old push broom. Usually only used on farms and other rural settings.

Source: www.lawnsite.com

I redecked my trailer last year and used the used oil/diesel treatment. Amazing outdoor protectant that lasts for years.airless sprayers work great if you don't have a compressor:

Source: www.jalopyjournal.com

I ended up using a 50/50 mixture of each and it worked very. I would even try a 25% oil with 75% blend and reapply as needed.

Source: www.lawnsite.com

After deck is dry apply a strong degreaser (i used mojo industrial degreaser by monster motor company, found it at northern tool, worked better than expected) with a pump sprayer scrub and rinse, it may take a couple cycles. Never use any gun oil on wood.

This 250 Voc Compliant Deck Stain Provides Protection For Your Wood By Blocking.

Used motor oil on wood deck. Soaks in good that way. Linseed oil is still one of the best concrete sealers and outperforms all the latest fancy chemicals on the market.

On The Flip Side, You Cannot Use This Method To Preserve Indoor Wood.

3 to 4 coats now and its good. Discussion starter · #1 · aug 15, 2019. I have never heard of such a thing.

It Gives V Good Protection But Ends Must Be Soaked In Oil For A Long Time To Be Effective.

The oil will darken and soften the wood. It's just wood and can easily be replaced and doesn't cost much. I would even try a 25% oil with 75% blend and reapply as needed.

Our Barn Is Wood Sided And Apparently It’s Common In This Area To Mix Some Concoction Of Diesel Fuel, Used Transmission Fluid And Whatever This Oil/Grease Is In The Barrels To Treat The Wood On The Barn.

The good ole boys down home in tennessee swear by a mix of 50% diesel fuel and 50% used (or new) motor oil or transmission fluid, depending on the desired tint, sprayed liberally on the deck. It keeps sipping deeper into the wood. The neighbors down the road swear by a mix of 50% diesel fuel and 50% used motor oil brushed on a wood deck as a great wood preserver.

After Deck Is Dry Apply A Strong Degreaser (I Used Mojo Industrial Degreaser By Monster Motor Company, Found It At Northern Tool, Worked Better Than Expected) With A Pump Sprayer Scrub And Rinse, It May Take A Couple Cycles.

As always though, all the best things are bad in some way, and old engine oil has all the obvious. Spruce on the little trailer is from 1994 and the steel frame is in worse shape than the wood. It made the wood water resistant and the dark oil gave it a nice colour.